Garage doors are most often neglected when it comes to seasonal inspection and maintenance, but neglecting them can cause stress on an automatic garage door opener. Spending just an hour or two every spring and autumn performing routine maintenance can save you from having to pay a hefty garage door repair bill. If you want a method to make the most of your time, try scheduling your garage door check with other seasonal duties, such as storing your lawn sprinklers for the winter and turning them back in the spring.
Your garage door and opener are used almost every day, so it’s crucial to perform regular maintenance or perform garage door repair silver spring md to keep them working smoothly. By following the maintenance tips mentioned below, you can ensure the garage door operates smoothly at all times.
Weather-stripping
The rubber weather stripping on the garage door’s bottom not only keeps out water, dust, and debris but also keeps out the cold. Inspect it twice a year to verify that it is in good working order. Some weather-stripping employs a flange that slips into a groove in the garage door’s bottom, while others are stapled in place on wooden garage doors. If it is in bad condition, you should repair or replace it to ensure your garage stays dry and well-insulated.
Clean and Repaint the Door
When inspecting the other parts, don’t forget to look at the door itself. If the door is made of steel, look for rust patches that need to be sanded, primed, and painted. Use a general cleanser to clean fiberglass doors. Water damage and warping are common issues with wood doors, so special care should be taken. Sand and refinish areas where the paint is chipped and flaking. If your wooden door’s bottom edge is not weather-stripped, make sure it is completely sealed or painted before installing weather-stripping.
Examine the Door Balance
An improperly balanced garage door puts additional strain on your garage door opener, causing it to wear out faster. The door’s springs should be so well balanced that only a few pounds of power is required to lift it. On the automatic opener, pull the release handle and lift the door manually to about halfway open. The door should stay open without your assistance. If it doesn’t, the door isn’t balanced properly, or the springs are getting old and damaged. For garage door repair in Elkridge, contact a specialist.
Examine the Cables and Pulleys
Examine the lift cables and pulleys attached to the bottom roller brackets of the door. These act as a link between the springs and the door, allowing it to be lifted and lowered safely. Two types of springs for garage doors are extension springs and torsion springs. Extension springs are long, slender springs that run along the horizontal section of each door track. Above the door opening is a metal rod with tension springs attached to it. Cables lift both types of doors.
Check and Replace the Rollers
The rollers along the edge of the door must be inspected and replaced at least twice a year. Throughout your inspection, replace any rollers that are damaged, chipped, or worn. You can remove the rollers by simply removing the brackets that hold the majority of them to the door.
Wrapping Up:
Regular maintenance is vital to keep your garage door running smoothly and avoid costly repairs. If you need professional maintenance services or garage door repair services in Clarksville MD, then look no further than Horizon Garage Doors. Contact us today for your local garage door repair or maintenance, and let us help you keep your garage door working smoothly.